Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Best Of
-
Re: Maestro works OK remotely, SSDR not so much
We got to the bottom of it. The rancher replaced a poorly performing bridge from the router in the house to the switch in the shop where the radio is. That got rid of just about all of the stuttering…1 -
Re: Official Position on Adaptive Predistortion
Dave, please let me answer Rob's accusations... Rob, 1) You accuse me of being a "fan boy" of Anan, but I'm not. I'm just a proponent of APD. So is John K3MA, per his October…1 -
Re: Official Position on Adaptive Predistortion
Rob, 1) The waveform in the screenshots is a snapshot of the RF output of my AL-80B as captured by and displayed in Thetis. That is the exact same waveform you'd see if you piped the same signal…1 -
Re: Maestro C
If only it was that easy. Well I found out by closely reading the Specs that the MIC Jack is NOT a 1/8" TRS like the 6400M or 6600M but a 1/8" TRRS Headset Phone wiring. It is a Balanced MI…1 -
Re: Porting the FlexVSP COM driver to Win 11 ARM
Thanks for asking this. I have this same question. Thanks, Jason KD9ZHF2 -
Re: Mic Audio Just stop working
You need to be sure that you have PC selected and that DAX is off. To use a mic plugged into the computer, you need to set it as the default recording device.1 -
Re: FLEX-6700 for sale
Flex-6700 is sold pending successful transfer of funds.1 -
Re: FLEX-6700 for sale
Very nice! I have often thought of selling or trading my 6600M for a 6700. Good luck on your sale. James WD5GWY1 -
Re: Maestro C
The EU is a bit of a different challenge with all the testing that has to happen. Much more strict that the US. You would not believe the cost to do testing for emissions on electronic devices.3 -
Re: Maximum Power for TGXL
Hi Dave, Thanks for the advice as always. Even though I'd already done all of that (including using AG v4.1.7) following advice you gave me previously, I did factory resets on both the TGXL and …1
