Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Best Of
-
Re: My order checklist for Q5 transverters to work sats with my 6600 - Does this look correct?
I did a 50Mhz on one of my transverters as a test which will give you 4Mhz bandwidth on VHF as you selected. But, there is no reason why on an 2 SCU radio that you can't have 28Mhz on both transverte…1 -
Re: FLEX 8K6 v31010 does not work with SDC Skimmer ....
HI Len, tnx for the advice, I have just downgraded to v3823, it works and keep the fingers crossed. 73 Phil IU0EBV1 -
Being prompted to buy a license after installing v3.10.10?
If you already had a SmartSDR v3 license and you're being prompted to buy a license after installing v3.10.10, please make sure that your radio has internet access. The radio is setup to pull licensi…1 -
Re: Excessive splatter?
Hi Justin, you can't judge signal quality by looking at the transmit signal that way. If you want the real picture, you need to open a second panadapter and put the rig into Full Duplex (FDX). Then p…1 -
Re: Mouse movement causes frequency change. this is critical.
Thanks folks. I have no problem moving the mouse from screen to screen properly. I did move the SDR to the 'main' screen just to see if the problem remained with only one monitor in use. I hate to sa…1 -
Re: Mic connection
I have seen some people use one of these and then the plug the Heil mic into one sockets. I think it is the red one. It is easy and safe to test. It will either work or not work. let us know how you …1 -
Re: Mic connection
To connect a Heil microphone with a 1/8" TS (mono) plug to a FlexRadio that requires a 1/8" TRS (stereo) input, you need to prevent the shorting that occurs when the mono plug bridges the t…1 -
Gaming Headsets - What works for you?
Good morning all I love trying out headsets, so on a wim, I ordered a Razar Blackshark X Gaming headset. It has a volume control on it and it has a Mic mute, which I accidentally touch causing me to …1 -
Re: Tuner Genius Not visible on the SmartSDR 3.9.19 App
Hi Steven, I was one of the people who reported the problem to 4O3A and their response was the problem is on Flex’s end. And based on my interactions with competent people at Flex, that’s probably co…1 -
Re: Ukranian transverter setup
You can also open the transverter and add a wire jumper between the "OUT 28" and "INP 28" jacks. You then have a common IF transverter and can use a single RF cable connected to t…1
