Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Strange MOX issue

Les Brown
Les Brown Member ✭✭
in FLEX-6000 Signature Series

After a network disconnect between my radio and remote Maestro earlier this week, strange behaviour started. When I key cw with a paddle attached to the remote Maestro, intermittently MOX stays enabled after I stop sending, or flashes off/on/off one or more times for a couple of seconds after I stop sending. This problem does not occur when I send canned messages in N1MM that is running on the computer at the station.

Has anyone seen this kind of problem before? I will likely have to visit the station soon to reset my Flex6600M in the hopes of fixing this.

Comments

  • WK2Y
    WK2Y Member ✭✭

    No, but using CWSkimmer with a 6500 locally, when Skimmer starts, MOX gets turned on. Very odd.

    73,

    Bob, WK2Y

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    I opened a support ticket for this.

This discussion has been closed.

Categories