Will there be a maintenance release for the maintenance release?

ka9ees

I have been having start up inconveniences. Today I left the rig on with no client connected. Decided to start it with smart control. The client started, but showed no panadapter. I restarted the client a couple times. Same result, but then the power button started blinking green. With no input from me. It then started blinking red 2 times and finally shut itself down.

I next did a cold boot. This time I decided to start it from the front panel. It didn't boot. It said the update was complete. Choose a radio. There was an arrow to the right showing version. I hit that, selected v3.2.31 and it started. I am sitting in front of it now. All seems right with the world. I will start it from SSDR from my computer after this net.

Rig is a 6400M running v3.2.31.2837

73,

Ed KA9EES

Mike-VA3MW

@ka9ees

Hi Ed

Yes, when you start SmartControl there is no panadapter. The Maestro becomes a big FlexControl Knob when you run Smart Control. You then need to run a Client from some other source like a PC.

Am I missing something?

73

ka9ees

I was running SSDR for Win10 at the time.

73,

Ed KA9EES

ka9ees

Sorry Mike,

That is why I went to the front panel. It wouldn’t start with Smart Control. The front panel was unresponsive also. It’s running fine now. I have it set to auto connect last radio now.

73,

Ed KA9EES

ka9ees

@Mike-VA3MW

I did a terrible job of explaining. Sorry. I didn't take notes as it was happening. Did it from memory a few minutes later.

73,

Ed KA9EES