Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.

Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

---

The latest 4O3A Genius Product Software and Firmware

If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Best Of

• Everything
• Promote
• Insightful
• Like

• Re: Introducing Deck Master 6000 a Stream Deck plugin to control Flex-6000 series radios

  K1DBO

  June 2023
  Just a quick note for the folks playing along at home... I've made a number of tweaks and bug fixes and have updated the release at github. You can check your installed version number by right c…
  2

• Re: FLEX-6400: 60Hz Hum with Isolation Transformer. Resolved, But Why?

  Erika - KØDD

  January 2024
  Sometimes you need to pull every plug out of your station and start building from Box A and Box B and test with every piece after hooking things up. You can never have enough GROUND... I finally dril…
  1

• Re: FLEX-6400: 60Hz Hum with Isolation Transformer. Resolved, But Why?

  Ken Wells

  January 2024
  Depending upon what you had connected to the mixer, you may have had a Pin 1 problem, or you may have had a ground loop but were isolating the wrong input or output with the isolation transformer. OR…
  1

• Re: FLEX-6400: 60Hz Hum with Isolation Transformer. Resolved, But Why?

  Mike-VA3MW

  January 2024
  I agree with Geoff. This sounds like what is called a Pin 1 problem.
  2

• Re: FLEX-6400: 60Hz Hum with Isolation Transformer. Resolved, But Why?

  Geoff AB6BT

  January 2024
  Any chance of a drawing showing exactly how it was wired with and without the transformer(s)?
  1

• Re: With a router having UPnP enabled should/can ports still be forwarded?

  Mike-VA3MW

  January 2024
  I think the bigger problem is why do you have to keep resetting the radio? On my contest (home radio) I haven't reset it in years it seems. What sort of problem are you seeing that requires a re…
  1

• Re: 6600M Chimes on TX

  DBC

  January 2024
  Update. First, thank you, everyone, for the comments and suggestions. I resolved my issue, or at least made it acceptable, and wanted to share in the event someone runs up against it. Everyone was on…
  2

• Re: Introducing Deck Master 6000 a Stream Deck plugin to control Flex-6000 series radios

  K1DBO

  June 2023
  Deck Master 6000 is now available from the StreamDeck plugin store. I'll keep publishing new releases and attempting to maintain the documentaion at GitHub too. Since the plugin store provides a…
  1

• Re: TeensyMaestro

  Lasse SM5GLC

  January 2024
  Spent some time with 1.042 and concentrating on the CW issue. Did the same "testing" as with 41, and it seems that the debounce issue really was causing my problems as I have yet to notice …
  1

• Re: Interlock is preventing Transmission AMP-TG

  Ken Wells

  December 2023
  I had this issue immediately after updating the firmware on my TGXL and AG. It persisted until I powered everything down -- radio, amp, tuner, and AG, and turned them all back on again. It hasn'…
  1

Previous Next