Flex 6700, N1MM Logger+, Ctrl+Enter, or Ctrl+Fn

  • 1
  • Problem
  • Updated 3 years ago
  • Solved
  • (Edited)

I use the following feature of N1MM Logger+ in my current
SO2R setup, described in Paragraph 2.8.2.6.3 of the N1MM Logger+ online documentation:

“Ctrl+Enter, or Ctrl+Fn - Using these commands will send the corresponding message on the alternate radio; with the alternate radio defined as the radio that does not have RX focus.”

This a highly desirable feature for effective SO2R.

I am unable to get this feature to work consistently with my Flex 6700.  I only occasionally see the TX slice change and I always get the following information pop-ups: “SmartSDR The antenna may not be changed while transmitting” and "SmartSDR Transmit Slice has not been selected." 

The only way I can reliably switch from TX Slice A to B (and vice-versa) using N1MM+ is by using Ctrl+left or right arrow.

Related to the above, the Dueling CQ feature of N1MM Logger+, described in Paragraph 2.8.2.3 also exhibits similar behavior.

I am not sure if this is an issue with the Flex 6700 or N1MM Logger+.  I have also submitted a N1MM Logger+ bug report.

73, Bud AA3B

Photo of Bud Trench

Bud Trench

  • 7 Posts
  • 3 Reply Likes

Posted 3 years ago

  • 1
Photo of Bud Trench

Bud Trench

  • 7 Posts
  • 3 Reply Likes
I solved this issue.  The fix was to go the N1MM Logger+ Configurer and increase the PTT Delay for the Winkey.  I set it at 350 msec and all seems to be working now.
(Edited)

This conversation is no longer open for comments or replies.