Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

SmartSDR for Mac -- Adjusting tuning rate

Options
Doug
Doug Member ✭✭
in SmartSDR for Mac

I'm getting up to speed on SmartSDR for Mac. So far, the FlexControl doesn't work. Now I've tried the Icom RC-28, which is a very nice device. It does work, but the default tuning rate is far - FAR too fast. I've tried to find where the tuning rate can be adjusted. In the manual, there is this:

image.png

However, I cannot find this device anywhere even after searching every menu. If it's here, I cannot find it. Right now, I'm pretty frustrated with this software.

Comments

  • W7NGA
    W7NGA Member ✭✭✭
    edited December 2025
    Options

    I don't have the RC-28 but you can control the tuning rate, in general, by setting the step-size parameter for each slice. Mouse and Trackpad have separate settings for sensitivity should you revert to those tuning devices.

    W7NGA

  • Doug
    Doug Member ✭✭
    Options

    It's in the next line below this one, on the far right…where it says STEP.

Categories