Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Don't be that guy

frc2302
frc2302 Member ✭✭
in FLEX-6000 Signature Series

It is best to finish your coffee before connecting RF equipment.

Early this morning, I mistakenly connected my Rigexpert Stick Pro to the wrong end of the coax, and measured the #1 antenna port of the TGXL, which of course was connected to the Flex 6400 at the time. Strange readings, that. 🙄

I was not near the operating desk, so if there were any protection errors displayed, I missed them, and the receiver still seems to work normally. It appears from the product literature of both companies that the Rigexperts output about -10dBm, and a Flex won't complain until we hit +8dBm, so my read on this little mishap is that there is no chance it could have caused damage.

It's totally ok to chuckle. Just wondering if my assessment is accurate.

Comments

  • Erika - KØDD
    Erika - KØDD Member ✭✭✭
    edited February 2025

    The radio will give you an error and trip out due to too strong rf coming in. My 6500 would. It does reset. But you don't want to be doing that though. Bullet dodged. I thought you measured the output of the radio to the rig expoof... that might have started a bit of a fire. That wouldn't have survived. I like my antenna analyzer (55) to blast it up... they are nice devices. DD

  • frc2302
    frc2302 Member ✭✭

    No, the only thing generating RF was the analyzer, fortunately. Not that much drama …

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories