Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Flex 6400 transmit squeal

rogerhoffman
rogerhoffman Member ✭
in FLEX-6000 Signature Series
My Flex 6400 transmits a squeal instead of audio when I go into transmit. Using an FHM-2 mic. Worked fine and then just started the squeal. Any ideas?

Answers

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Roger, do you have MON turned on? If so, either turn it off or use headphones with the speakers muted.

    image.png
  • rogerhoffman
    rogerhoffman Member ✭
    The squeal is on the transmitted signal, what goes out the antenna....
  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Can you post a screenshot of SmartSDR?

  • rogerhoffman
    rogerhoffman Member ✭
    When I press the mic button and speak, I just get a squeal (in another receiver, and from an on air report). Last time my voice was squeaky was 60 years ago!
  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Roger, I don't see anything amiss. When you transmit, where is the peak level indicator?

    image.png

    On voice peaks, it should not exceed 0 dB and therefore never turn red. Somewhere around -5 dB (as shown above) is about right. Note that it is the peak indicator rectangle, not the average bar that you should be watching.

    If this is not the problem, then you might be getting RF into your audio somehow. A test at low power should help identify it that is a problem or not.

    And, finally, to cover the obvious - do you have another receiver on in the same location on the same frequency?

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    It would be better if you can post a video of what is happening. There are numerous settings that might make this happen

    If there is a squeal on your transmitted signal, then share a video while talking into a dummy load.

    It could be a bad mic, RFI, and a few other things. Right now, we don't have enough to go on.

  • rogerhoffman
    rogerhoffman Member ✭
    Len, KD0RC: A couple short videos on their way to you via your ARRL e-Mail....can't post videos here, apparently.

    Thanks.

    Roger, KW9G
  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    You should be able to attach a video as others do. If not, just upload it to YouTube and provide the link here.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories