Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Slicemaster Frequency Problems with SmartSDR

Mark Griffin
Mark Griffin Member ✭✭✭
edited May 2024 in SmartSDR CAT

I am running two instances of WSJT-X. Slice A is 160 meters and Slice B is 10 Meters. But when I bring up Slicemaster and have two instances of WSJT, the Program will then change Slice A to 10 meters. And Slice B is still 10 Meters. Why can't I have 1 WSJT reading 160 and the other reading 10 meters. Is the way I have WSJT Set up for radio that is messing the whole thing? Under the radio tab the Network Server is 127.0.0.1:7831 and for Slice B it is 127.0.0.1:7831 I just switched Slice A to 160 and after about 5 seconds it then duplicates the frequency on Slice B which is 10 meters. WHAT IS THE PROBLEM??????

Mark Griffin, KB3Z

Comments

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    this is a duplicate

This discussion has been closed.

Categories