Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

PGXL Temperature Rise

Member ✭✭
in Power Genius XL Amplifier

I lately noticed that when I turn on my PGXL and put it into OPERATE mode the PA heatsink temperature rises to between 50-52˚ when just idling. I have not transmitted since turning it on. The current draw is about 4A. When I put it in STANDBY the temperature drops to about 45˚ after a few minutes. The harmonic load temperature stays at about 29˚ or so and rises slightly when transmitting. If I place the amp back into OPERATE mode, the temperature steadily rises again to over 50˚ while idling without transmitting. This does not appear to be normal behavior. I think I recall lower idling temperatures in the past.

Can anyone comment about this?

Tagged:

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • Member ✭✭✭

    Open a help desk ticket.

  • Member, Super Elmer Moderator

    What speed are the fans in?

    Whay version firmware?

    Dave wo2x

  • Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    You'll find the temperature rises based on the BIAS current.

    I ran RTTY all weekend at 700 watts and never got over 50C, but I am on the latest version.

    We have done a lot of work on the firmware/fans and Bias, so the version is critical.

  • Member ✭✭

    Firmware version is 3.8.4

  • Member, Super Elmer Moderator

    Try upgrading to 3.8.8

    Dave wo2x

  • Member ✭✭✭

    Thanks Dave, 3.8.8 seems to have improved the cooling with the fan cycles. Now the next feature I wish for…is Auto-Standby, after x hours of inactivity. With x being a setable value like 2,4,6 hours.

    73, Bill

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories