SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Power Genius XL RF Early Warning

I'm trying to use my Icom 7610 today with the Power Genius. On CW when I attempt to transmit I get the warning "RF Early" warning. Using the latest version of software...SmartSDR and the Power Genius. I have set the transmit delay to 30 ms without any change in the warning.
The Icom is connected via CI-V and the Tuner Genius is in line with low swr. Does anyone have a suggestion of what maybe is causing this issue.
The flex works fine...just the Icom.
Comments
-
Try increasing the delay in increments to help explain what is happening.
73
Bill W9JJB
PS on 60m be sure to decrease the high end cutoff below 3000hz and don’t use the split or fake it. Either of these two things could allow TX outside the permissible band restriction. Flex would then inhibit TX.
0 -
The delay is at the maxed to the limit...thanks for the response...
0 -
Hi Ronald,
You may wish to open a support ticket for this.
m
0 -
Thanks for the advice Mike...
0
Leave a Comment
Categories
- All Categories
- 354 Community Topics
- 2.1K New Ideas
- 618 The Flea Market
- 8K Software
- 3 SmartSDR+
- 6.3K SmartSDR for Windows
- 175 SmartSDR for Maestro and M models
- 413 SmartSDR for Mac
- 267 SmartSDR for iOS
- 252 SmartSDR CAT
- 188 DAX
- 376 SmartSDR API
- 9.2K Radios and Accessories
- 24 Aurora
- 217 FLEX-8000 Signature Series
- 7.1K FLEX-6000 Signature Series
- 923 Maestro
- 53 FlexControl
- 861 FLEX Series (Legacy) Radios
- 897 Genius Products
- 456 Power Genius XL Amplifier
- 325 Tuner Genius XL
- 116 Antenna Genius
- 286 Shack Infrastructure
- 201 Networking
- 445 Remote Operation (SmartLink)
- 140 Contesting
- 759 Peripherals & Station Integration
- 139 Amateur Radio Interests
- 979 Third-Party Software