Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

FT8 DXpedition Mode Setup FlexRadio 6600

Options
Member ✭✭
edited December 2019 in FLEX-6000 Signature Series
Hello, in a few hours I'm planning to take part on the third public test of FT8 DXpedition mode, on my new Flex 6600 do you have to have panadapter A and B to run split or just FakeIt as the settings on WSJT-X ?


What should be best setup for this test ?

Welcome!

It looks like you're new here. Sign in or register to get started.

Answers

  • Member ✭✭✭
    edited December 2019
    "Fake it" works fine, and is recommended by many.
  • edited December 2019
    Use the WSJT-X software to do split.
  • Member ✭✭✭
    edited May 2018
    Get the document that JT has on his site.  FYI...  He recommends or tells you to set to "Fake It".  Good Luck!
  • Member ✭✭✭
    edited May 2018
    I should have been a bit more verbose in my response - split also works, BUT you lose a slice for the split. If you don't mind that, you can use it. Ted VE3TRQ
  • Member ✭✭
    edited May 2018
    Thanks Ted, since the Flex can do that and perhaps more then why not and just go for the simple and Fake It !
  • Member ✭✭
    edited May 2018
    W7/KH7Z 14.115 right now.  Just got him with the 6400/vertical.  This DXpedition mode is pretty cool.
  • Member ✭✭
    edited June 2018
    Fake it

Leave a Comment