Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

What is the offical way to connect a receive antenna (small magnitic loop) to the 6500 series? Have

N0AZZ
N0AZZ Member ✭✭
edited June 2020 in FLEX-6000 Signature Series
What is the offical way to connect a receive antenna (small magnitic loop) to the 6500 series? Have searched but not found a good way to do.

Answers

  • Andreas Junge
    Andreas Junge Member ✭✭
    edited April 2019
    Hook it up to the XVTR port and then select the XVTR port as RX antenna.

    imageimage73, Andreas, N6NU
  • George KF2T
    George KF2T Member ✭✭✭
    edited February 2019
    XVTR or RXA port. Easy and safe with a BNC connector. You can use either of the UHF ANT connectors, but recommend you not, since it is possible to transmit through them. That’s bad for the loop :-)
  • ctate243
    ctate243 Member ✭✭
    edited June 2020
    I was gonna say.. -perhaps the RXA or RXB bnc ports.
  • Ken - NM9P
    Ken - NM9P Member ✭✭✭
    edited October 2017
    On a 6500, it would be the RXA BNC port.

    You could also use the XVTR port , but the TX/RX switching would probably be cleaner with the RXA.

    I agree with others, I wouldn’t recommend using the ANT2 port for a receive only antenna, especially if it has active devices in it.... that is a disaster waiting to happen if you forget and transmit into it. BTW... For those with a 6300, which has no RXA port, 6300 users would need to use the XVTR port for receive only antennas.
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited October 2017
    To the RX-A port for a 6500

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories