Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

V1.3.8 is not initializing AM mode in RX at start-up....

Options
k0eoo
k0eoo Member ✭✭✭
edited March 2017 in SmartSDR for Windows
When I start-up my 6500 on my PC running W7 and V1.3.8 I noticed the S-meter does not read correctly if the Slice I'm on is in AM mode....  It reads very low...  To correct all I do is select some other mode on that slice and re-select AM and all is well...  I've been able to repeat this behavior many times...

This is just a heads-up for the FRS team...  This issue is not causing me any problem, just thought the team would like to know.  Regards, Dennis, k0eoo

Comments

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited March 2017
    Options
    Are you using SAM or AM?  Is there a difference if you use either of these modes?
  • k0eoo
    k0eoo Member ✭✭✭
    edited March 2017
    Options
    Hi Tim,

    I was in the AM mode each time this happened....  I didn't understand your second question.

    Dennis, k0eoo
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited December 2016
    Options
    Since you are using AM, does the same behavior happen with SAM?
  • k0eoo
    k0eoo Member ✭✭✭
    edited March 2017
    Options
    The answer is no.  I usually only use the SAM mode during QSB conditions so I have never had the occasion to start-up my 6500 with it in SAM mode....

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories