Unhandled Error (Non-UI Thread)

VA7DX

After a recent series of Windows 10 updates I'm now getting the following error when I try to load SmartSDR 3.6.8 on my home computer which is remoting into my 6700 about 30KM away.. I've tried reloading the softwaare to no avail.
I've attached a couple of JPEGS showing the error and the updates that occurred yesterday and today.
I've been running flawlessly for months until now...

Any suggestions?

Neil
VA7DX

KD0RC

Hi Neil, I would go out to your radio site and upgrade to 3.8.20. There are enough improvements to make the trip worth it (assuming you don't have to hike up a mountain to get there).

VA7DX

Thanks Len. I've held off on the update as 3.6.8 has been pretty stable for me but I will bite the bullet and do that tomorrow.
One night of radio withdrawal shouldnt be that bad..... I hope ...:)

Thanks for the response
73
Neil
VA7DX

VA7DX

It looks like I may have soled the problem by deleting the SmartSDR config files in APPData on my home Win10 machine. I'll post an update after I've run for a day or so.
Neil
VA7DX

Jim NO0B

I've recently gotten several unhandled errors with SmartSDR CAT 3.8.20.34503.
I wonder if that has anything to do with the intermittent failure to display spots on the panadapter?

Mike-VA3MW

UHE's need to be reported in a support ticket. thanks