Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

SO2R signal attenuated on no focus TX slice

Options
sq9orq
sq9orq Member ✭✭
edited October 2024 in Contesting
I use Flex 6700 + Mestro for SO2R operation.
There was a problem with SO2R operation, because the signal is attenuated by about 10-15dB on a slice where TX is not selected. The signal drop on a given slice is audible and visible on waterfall.

-Slice A has ANT A, Slice B has ANT B
-RF Gain = 0 on both
-Independent of software version (I checked)
-Independent of attached FDX
-Factory reset of 6700 performed
-Antennas directly to socket in 6700 (ANT 1 and ANT 2)

What to do so that the signal level does not decrease when I change TX focus.

Answers

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin
    Options

    support ticket created

This discussion has been closed.

Categories