how do you hook up a Power Genius XL to a ic-7300 radio with a Tuner Genius XL 1x3 tuner ?

poopy

:)

Erik Carling EI4KF

Does it help to see

https://community.flexradio.com/discussion/8028950/how-do-i-interface-both-pgxl-and-tgxl-to-an-icom-ic-7300

Plus from Flex: https://helpdesk.flexradio.com/hc/en-us/articles/360042472572-Interfacing-a-PGXL-to-an-Icom-Exciter-using-the-CI-V-Interface

David Decoons, wo2x

You need to run a mono 3.5 mm male to male cable from the radio CI-V out to PG XL side A CI-V in.

Radio PTT out to PTT A in on amp.

Connect coax from radio Ant 1 to PG XL Drive A.

If you have an external wattmeter and/or tuner, the output of the PG XL goes to the wattmeter, then tuner, then antenna.

Set radio TX Delay to 30 ms.

In PG XL utility, on CAT/CI-V tab, check A side, select Icom and set baud & CI-V address to match radio’s baud & CI-V address. Default CI-V address for the 7300 is 94. Default baud rate is auto so set amp to 9600 baud.

Have fun!

Dave wo2x

Presale Technical Support