Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Maestro B upgrade to 3.7.4 failure

buzzkill58
buzzkill58 Member ✭
edited May 2024 in Maestro
I upgrade my Maestro B and 6600 to 3.7.4. My 6600 worked fine with SmartSDR 3.7.4, but my Maestro B went wacky. I could set the Maestro to transmit, but the 6600 would remain in receive. If I shut the Maestro down, the 6600 would kick into transmitting an carrier and had to be shut down to stop the transmission. The Maestro B would controls would lock up and the spectrum freeze, but I did not figure out a repeatable sequence to cause that to happen. I was able to downgrade every thing to 3.7.3 and restore normal operation.

I’ve seen a few post about the A having upgrade issues. I am wondering if anyone else has experienced a B upgrade issue. It this point I am a little torn with submitting a ticket vs just waiting for the next release.

Comments

  • KD0RC
    KD0RC Member, Super Elmer Moderator

    I would submit a ticket.

    73,

    Len, KD0RC

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    I created a ticket for this. Thanks for your patience

This discussion has been closed.

Categories