Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Possible Bug in PG Utility

All:

I looked but I did not see this one covered or reported.

I just loaded Firmware 3.7.28 to my PGXL. I found that if I "click" in the Band Source Field, PG Utility GUI stops responding to commands such as Operate and Standby while connected in a network. While toggling between Operate and Standby is available in SSDR, and FRStack, it locks the PG Utility from functioning.

A reboot of the PGXL does solve the above problem provided the user does not again attempt to view data in the Band Source Field.

73

Rich, AJ3G

Comments

  • Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    I created a support ticket for this.

Leave a Comment