Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Smart SDR Meter No Longer Work?

Bill AB7AA
Bill AB7AA Member ✭✭✭
in Power Genius XL Amplifier

Upgraded SmartSDR to 3.2.31 and the PGXL meters no longer work. The amp is fine (Firmware 3.5.23) and the meters work well on the utility 2.2.10 but not on SmarSDR. Any ideas as to what to look at?


Bill

Answers

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    @Bill AB7AA

    Can you power cycle the amplifier and see if the problem resolves itself please.

  • Bill AB7AA
    Bill AB7AA Member ✭✭✭

    Mike,


    I tried this already including unplugging and replugging the AC. I've tried a lot of the usual recycling remedies. The meters work well on the utility so I think that the amp is okay. I can put the amp into operate and transmit from Smart SDR but not read the meters.

    Bill

This discussion has been closed.

Categories