Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

No transmit audio in WSJT-X

2»

Comments

  • David Decoons, wo2x
    David Decoons, wo2x Member, Super Elmer Moderator

    Have you enabled DAX TX in right panel in SmartSDR?

    in DAX control panel DAX TX should be blue. Do you see the level meter in DAX control panel moving? Set WSJT-X power all the way up and set DAX TX to 48. That should pt TX level right at zero without clipping.

    Set TX audio frequency in WSJT-X around 1300. In WSJT-X setup under radio on right side set TX to CAT. Set mode to Data/Packet, set shift to Fake It. Fake It keeps TX between 1500 and 2000 Hz over the air.

    last, set TX bandwidth to 100-3000

    73 Dave wo2x

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    This is a great thread, I've read through all the messages and can't get any RF power from my Aurora.

    Anyone still monitoring this thread? I need help. -Rod KU0W

    Can you expand on this please. Is there no RF at all or just when using WSJT or some digital program.

    If the later, I run digital modes on my AU-520 all the time and there is likely some sort of configuration issue. The digital setup is 100% identical to any FLEX-6000 or FLEX-8000 radio. If you can share a screen shot of digital program that shows the radio config and the audio config as well as entire screen of SmartSDR that would help.

    Usually, it fails due to DAX not being configured correctly.

    This video might help you out.

    https://youtu.be/RXeMMayB3-o?si=q8yC68eDNhw54Mri

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories