Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Best Of
-
Re: Interlock is preventing Transmission AMP-TG
While not happening as frequently as it has previously, it still is happening. I noticed during yesterday's contest, all of a sudden during a transmission I would receive a warning message about…1 -
Re: Smartlink port forwarding on Ubiquiti DMPro
Here is my '6400 Network: Yours looks good to me ... No, you don't need a fixed-IP from your ISP. The Flex appears to liek-and-use it's own choice of 255.255.255.248 which is more-cons…1 -
Re: FLEX 6400 M internal speaker
Press Menu on the front panel. Press "Audio". You will see "Front Speaker". Press "enabled" and it will then read "Disabled". Press "Exit at top left. Fix…1 -
Re: HELP with SmartSDR CAT and FLDIGI
I found that after initializing my RigCAT setup, I had not only to save, but to close FlDigi and restart it. Then things worked really well. I also found that it always helps to open SmartSDR CAT and…1 -
Re: Smartlink port forwarding on Ubiquiti DMPro
@WY5PER UPnP is the spawn of the Devil ☹️ Please exhaust any and all other ideas before UPnP. I also use a UDM-Pro, with 8.0.24 software. Port Forwarding has proven solid and reliable in my case. Alt…1 -
Re: DAX Driver Error on NEW Windows 10 (or 11) installation
I just got a 6400 (non-M) and was excited to get things set up, only to discover that I have to disable effective security on my PC to make it work? Incredibly disappointing. This issue seems that it…1 -
Re: Smartlink port forwarding on Ubiquiti DMPro
Make sure you review the setup in Chapter 8 of the SmartSDR manual as well regarding using a manual setup. It does not have to be the same ports, but any ports of your choosing. If you use uPNP on yo…1 -
Re: Official Position on Adaptive Predistortion
Give me a break they wouldnt even spend extra to put a standard compatible mic jack on the M models, and used cheap power poles so they wouldnt have to provide fuses, what makes you think their going…1 -
Re: 6600M Chimes on TX
As Len, KD0RC mentioned, used lots of MIX 31 toroid's at the Antenna Feed Point, and Before your Coax and other cables come in the Station and on the Ethernet cables Ends, Speaker cables Etc. Pa…1 -
Re: 6600M Chimes on TX
One final comment... I have a seven element yagi on a temporary short tower (25') that is located only about 30 feet from the shack. I forgot about seeing this same issue whenever the antenna is…1
