Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Best Of
-
Re: 10 MHz Ref Input
Section 40.8 of the SmartSDR Manual The radio monitors each of the inputs and indicates which have a signal present with the blue marker. The Temperature Compensated Crystal Oscillator (TCXO) is part…1 -
Re: network question
@Arizona Mike What we are learning is that not all networks are created equal even if it is 10Gb Fiber. Speed doesn't always top latency. You think it would, but it doesn't. We can share things that …1 -
Re: Flex 6600 No signal processing on Panadapter
Ok Mike, Ty!1 -
Pointers to v2.9.1
Just a note to whomever manages the 'home page' of the Community: The 'header' at the top of the community is still pointing to 2.8.1 as the latest version. It should be pointing to 2.9.1, right? :-)1 -
Re: Help on Maestro Connection to 6600M on home wifi and home wired LAN
Ferrite Beads = Prayer Beads :-O Far better, for EMI suppression (both in, and out), is to use large toroids (FT240-31) with 8 - 10 turns of the cable. Place these toroids at each end of every cable.…1 -
Re: TX audio distorted after a few days being on.
I have a 6400 that has very bad tx audio distortion. I have had it less than six Months. Apparently this tx distortion issue is occurring back in 2020 too and has gone unresolved escaping their test …1 -
Re: Full Duplex satellite work on 6400
To elaborate on K9YK's explanation, in the 6400 hardware manual, chapter 12, there's a nice diagram showing the antenna connetion points and routing: https://www.flexradio.com/documentation/flex-6400…3 -
Re: Flex 6600 No signal processing on Panadapter
Hi David There is something not correct with this radio. I see you opened a support ticket. They will take care of you. 731 -
Re: TG XL and Antenna Genius 8X2
As long as not doing VHF/uhf, those lengths are an insignificant fraction of a wavelength on hf. If the coax and connectors are good quality, there should be no issues.1 -
Re: Full Duplex satellite work on 6400
Hi Eric, if both transverters are on the same IF, you won't be able to use Full Duplex. If you have one on a 28 MHz IF and the other on a 50 MHz IF, then Full Duplex should work. This would require a…1
