Yaesu MH-31A8J Mic

  • 2
  • Question
  • Updated 7 months ago
  • Answered
I assume this mic will work with the MAESTRO. I hate to make assumptions. I was looking at the connection schematic, it shows a fast, up, down switches, I assume those are not connected in the MAESTRO.
Photo of Bob G   W1GLV

Bob G W1GLV

  • 679 Posts
  • 114 Reply Likes

Posted 3 years ago

  • 2
Photo of N4TTY

N4TTY

  • 48 Posts
  • 4 Reply Likes
According to the Maestro User Guide:


Steve G./N4TTY
Photo of Bob G   W1GLV

Bob G W1GLV

  • 679 Posts
  • 114 Reply Likes
Steve I looked at that illustration in the Maestro manual. If you go and check the Yaesu site for the connections on the MH-31A8J you will find some that don't match. If the up,down & fast are not used on the Flex Maestro circuit board, then everything is good. Thanks for the reply.
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3479 Reply Likes
It should work.
Photo of Bob G   W1GLV

Bob G W1GLV

  • 679 Posts
  • 114 Reply Likes
Thanks Tim.
Photo of Warren Wegerer

Warren Wegerer

  • 1 Post
  • 0 Reply Likes
Bob, I'm wondering what you found with your MH-31 experiment? I know the wiring should work , but the MH-31 is a dynamic mic and I believe the Flex mics are condenser type. I'm guessing if it worked you  deselected Bias, and perhaps used the +20dB boost. What was your result with the MH-31 and what settings do/did you use if it was successful?