TX2 will not stay enabled

  • 1
  • Question
  • Updated 1 year ago
  • Answered

I have a6700 using 913.173 software...I have SO2R set on ANT1 and TX1 and slice B set to ANT2 and TX2 using the 4O3A switch to switch my Alpha between the two slices... I set the radio to enable TX1 and TX2 and the setup works until I change slices then TX2 goes to

disabled and only TX1 is enabled and both slices key with it..... is this a software bug??

Photo of Bruce Croskey

Bruce Croskey

  • 38 Posts
  • 1 Reply Like

Posted 1 year ago

  • 1
Photo of Larry - W8LLL

Larry - W8LLL

  • 341 Posts
  • 62 Reply Likes
Official Response

This one setting allows manual control of TX settings. I save my TX settings in TX profiles, with this setting checked DDUTIL no longer interferes.