Terrible Rumble / Wind sound on launch

  • 1
  • Problem
  • Updated 4 years ago
I power up the 6300, wait for green light to cycle until solid, launch software, and WOW.....sounds like a rumbling wind storm, the speakers about jump off the desk. This has now happened 4 times in the 1st week of owning this rig. I unplug  the power cord for a couple minutes, then it starts up ok. 
Photo of Steve Parker

Steve Parker

  • 40 Posts
  • 5 Reply Likes

Posted 4 years ago

  • 1
Photo of ROBERT WHITE

ROBERT WHITE

  • 8 Posts
  • 0 Reply Likes
Steve....I have noticed the exact same thing on my 6300. It has only happened about 3 times in a year. I just turn power off then back on and everything is fine. Can't figure it out either.
Bob. K9LWA
Photo of N8GL

N8GL

  • 1 Post
  • 1 Reply Like
I had the same issue with my 6300. I found that it seems to be related to RX equalization. By turning off RX equalization, it stopped the noise.  I leave RX equalization off, and have not had a startup issue since. 

Glenn N8GL
Photo of Jay / NO5J

Jay / NO5J

  • 1514 Posts
  • 222 Reply Likes
Glenn
I've seen that EQ issue with my 6500, turning it off stopped it too. I'm waiting for it to do it again so I can see if  immediately re-enableing matters.
Jay - NO5J 
Photo of Alan W4FBI

Alan W4FBI

  • 231 Posts
  • 30 Reply Likes
me too, with my 6300... Just happened once.
Photo of EA4GLI - 8P9EH - Salvador

EA4GLI - 8P9EH - Salvador

  • 1752 Posts
  • 534 Reply Likes
Glenn's fix is the same one that worked for me. If you leave RX EQ on when you turn the rig off and then turn it on it produces that annoying sound. Just make sure to turn RX eq off. This is definitely a bug. Has anyone reported it yet?