PTT Sticks when using VOX

  • 2
  • Problem
  • Updated 5 years ago
  • Acknowledged
Here is a new one that I just discovered.
on my 6500, using the latest 1.3 software.
If I am using VOX and push the PTT footswitch while talking and then let up on it, the PTT remains locked in TX.
I must turn the VOX button off for the rig to return to RX.

This happened very shortly after I had powered the rig up after a total power down (power supply off overnight,) and loading up one of my many Global Profiles.

I have repeated the effect several times.  Has anyone else experienced this?
Photo of Ken - NM9P

Ken - NM9P

  • 4241 Posts
  • 1355 Reply Likes
  • confused...

Posted 5 years ago

  • 2
Photo of James Kennedy-WU5E

James Kennedy-WU5E

  • 338 Posts
  • 35 Reply Likes

YES I have see the same thing, since unplugging the foot switch and going direct wire to the radio or using VOX it had not occurred again.  SETUP Heil PR-20 with a HBA or wired direct.

Jim

WU5E

Photo of Bob Wright, N7ZO

Bob Wright, N7ZO

  • 279 Posts
  • 76 Reply Likes
Hi Ken,

I confirm the same problem here.  Turn VOX on, talk to activate VOX, push and release PTT (my PTT is through pin 14 on the rear accessory connector) while VOX is activated, and the only way to get out of TX is to turn VOX off.

Flex 6700 with 1.3.0.116 client software, 1.3.0.41 hardware software. :-)
(Edited)
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9204 Posts
  • 3568 Reply Likes
I have written this up as a defect for further investigation.  Thanks for the report.