No Band Scope, No Waterfall.

  • 1
  • Problem
  • Updated 5 months ago
Working my 6500 remotely this morning I discovered that I can no longer get a display of the bandscope or the waterfall under any of my profiles.  When it first boots up there is a large triangular area sloping to the right and any tuning leaves a blank waterfall and no profile on the band scope.  The radio is functioning normally otherwise (tune, transmit, and hear other stations)
Photo of Steven La Mascus

Steven La Mascus

  • 4 Posts
  • 0 Reply Likes
  • Ahh my awesome radio isn't working right!

Posted 5 months ago

  • 1
Photo of Stephen Cook

Stephen Cook

  • 14 Posts
  • 5 Reply Likes
I have had this happen to me. The radio worked normally when using locally, but no waterfall or band scope when running remote. I ended up deregistering the radio from SmartLink and reregistering. After checking the ports (which were correct), everything worked fine remote again. I was never able to figure out what happened or why it happened., but this cured the problem for me.
Photo of Steven La Mascus

Steven La Mascus

  • 4 Posts
  • 0 Reply Likes
Thanks, I will check that out.  However the problem continues now that I am back at home so I conclude it is some display bug or setting that I have screwed up.

Photo of bahillen

bahillen

  • 122 Posts
  • 41 Reply Likes
Did you reboot the radio.
Photo of Steven La Mascus

Steven La Mascus

  • 4 Posts
  • 0 Reply Likes
yes, and I am reloading the program now.

Photo of Stephen Cook

Stephen Cook

  • 14 Posts
  • 5 Reply Likes
Have you tried rebooting your router?
Photo of Steven La Mascus

Steven La Mascus

  • 4 Posts
  • 0 Reply Likes
No but I will try that.

 It is a MacBook Air running parallels, and DogparkSDR works with band scope and waterfall. Not Sure where to go next.