Maestro reset

  • 2
  • Question
  • Updated 1 year ago
How do you reset the Maestro to factory defaults?
Photo of Bob G   W1GLV

Bob G W1GLV

  • 654 Posts
  • 109 Reply Likes

Posted 2 years ago

  • 2
Photo of K6OZY

K6OZY, Elmer

  • 532 Posts
  • 197 Reply Likes
There isn't a way.   Send it to Austin?!  :)
Photo of Mike va3mw

Mike va3mw

  • 824 Posts
  • 195 Reply Likes
There is no need. If you think you need a reset, just hold the power button for 30 seconds. Is there a problem you are trying to solve?

Mike va3mw
Photo of Dewey

Dewey

  • 19 Posts
  • 2 Reply Likes
If I press the Maestro power button down evenly for several seconds (instead of pushing down only the right side of the power button), a blue "Recovery" screen appears stating that I need to press the Windows key for UEFI firmware settings -- which gets me nowhere.  Holding right side of the power button down for several seconds, just turns the Maestro ON followed by a power-OFF, without any display notification.
Dewey, w0yww
Photo of Jay / NO5J

Jay / NO5J

  • 1514 Posts
  • 222 Reply Likes
Mike

There is no Left or Right side of the button. It is a single switch device. I suspect that if you are pushing on the right, you are not really making any contact or only partial contact.
I'm not sure where this came from, but it is a nice story.
mike va3mw
That came from a post here in the Community. I bet the member that posted it remembers posting it. When no one challenges the authenticity, of information posted here in the Community, it might get mistaken as peer reviewed fact.

What to do about it?
When?

Now might be a good time.

 SDRgadgets

73, Jay - NO5J

Photo of Gary

Gary

  • 52 Posts
  • 3 Reply Likes

Ok ... so now I'm thoroughly confused.... I have a new Maestro (as well as 6700) ... I tried to get the Maestro to connect to the 6700 without success... that was direct wired... then I tried through a switch, then through 2 different routers and finally via Wifi... I was never able to 'see' the radio through all this. Finally I was told to hold down the power button for 20 seconds to 'reset' the Maestro... I held it down and after what seemed like 12 seconds or so (yes I was counting) it seemed to 'act differently' and power up again - THIS time it worked. So - if that isn't a 'reset' - what is it!? And why did I have to do it to finally see the radio?


Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9148 Posts
  • 3467 Reply Likes
So - if that isn't a 'reset' - what is it!? 

It is a forced shutdown of the embedded Windows operating system so that when it restarts, it boots up completely rather than just "waking up".  A reset implies that parameters are reset to a factory default setting, which is not a feature of the Maestro. 
Photo of Jean Drolet

Jean Drolet

  • 73 Posts
  • 8 Reply Likes
TIM i have many soft on my maestro it's possible erase all i have v1.10.8 and more and i have many version alpha 
Photo of Eric - KE5DTO

Eric - KE5DTO, Official Rep

  • 678 Posts
  • 205 Reply Likes
Jean -- if you will write up a helpdesk ticket (helpdesk.flexradio.com), we can get this straightened out for you.
(Edited)