how to set 60m channels?

  • 1
  • Question
  • Updated 4 years ago
I finished building a 60m capable antenna yesterday so wanted to set up my Flex 6700 for 60m operation. I'd like to set memory channels for each 60m frequency but can't seem to figure out how to do this.
Photo of William Hein

William Hein

  • 95 Posts
  • 10 Reply Likes

Posted 4 years ago

  • 1
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1590 Posts
  • 555 Reply Likes
You could set up each as a global profile.
Photo of SteveM


  • 254 Posts
  • 40 Reply Likes
Photo of Mark - W3II

Mark - W3II

  • 135 Posts
  • 33 Reply Likes
If you are looking for a quick method to tune a slice to a memorized frequency visit the following post:


Photo of Tom


  • 47 Posts
  • 6 Reply Likes
I still like the way FRS handled this with the F5000 and hope they will incorporate it into the 6xxx series.
Photo of Jim, KJ3P

Jim, KJ3P

  • 88 Posts
  • 12 Reply Likes
Global profiles work fine for this, but better would be what we had with PowerSDR...successive clicks on the 60-meter band button brought up the next of the five successive frequencies, and around to the first again.  Very neat. Maybe in v2.0?

I've set up profiles for 60 meters in SmartSDR, and labelled them 60-1, 60-2, etc. These will be good for SSB and digital; CW would need a different set of frequencies, of course.
Photo of Tom


  • 47 Posts
  • 6 Reply Likes
I've also done the same thing with Profiles/60M. But it would be great to be able to select 60M, then click SSB and see the 5 freq. as in PSDR. Then select CW and see the other (adjusted) set of 5 freq.