heil proset elite headset adapter for 6400M

  • 1
  • Question
  • Updated 3 months ago
  • Answered
  • (Edited)
Looking for the adapter that will allow me to use my Heil Proset Elite headset with the 6400M.  The plugs on the end of the cable is 1/8 inch plugs.  Gray one has 1 ring and the black one has two.  Do these plug right into the 6400M.  i.e. mic and speakers.
Photo of KB4OIF

KB4OIF

  • 204 Posts
  • 25 Reply Likes

Posted 3 months ago

  • 1
Photo of Wayne

Wayne

  • 533 Posts
  • 63 Reply Likes
If it has the hc6 element like my proset has it plugs in direct and works fine but no mic bias used.+20db on. My gain is set around 60.
Photo of Wayne

Wayne

  • 533 Posts
  • 63 Reply Likes
Be sure to get the mic plug in the mic jack and the phone plug in the phones jack.
Photo of Wayne

Wayne

  • 533 Posts
  • 63 Reply Likes
It cannot be the proset elite ic that is for icom and will not work without an adapter
Photo of KB4OIF

KB4OIF

  • 204 Posts
  • 25 Reply Likes
OK which one is which.  I """""THINK""""" the black one is the mike????????
Photo of Wayne

Wayne

  • 533 Posts
  • 63 Reply Likes
The 1/8" mono plug is the microphone plug.
Photo of KB4OIF

KB4OIF

  • 204 Posts
  • 25 Reply Likes
Thanks Wayne.
Photo of KB4OIF

KB4OIF

  • 204 Posts
  • 25 Reply Likes
The gray one is the mike and the black one is the phones.   Seems to do very well but tried for about an hour yesterday.  40 meters was crazy. No one stateside on 20 meters, one very weak station on 17.  will try it on the net this morning.  
Photo of KB4OIF

KB4OIF

  • 204 Posts
  • 25 Reply Likes
The guys said it sounded good on the net this morning.  40 meters was in bad shape.  Seems to drive the flex a little harder with the same mic gain setting.