Having troubles getting the new version of DXLabs Commander to work with WSJT-x.
via the network system with the new version of Commander and Flex Radio communication.
I'm not sure of what to put into the port box.
I was able to get it to change frequency from either Commander of WSDR window but I could not trigger it to send the signal.
And then it would lock up and require a reboot.
Now I get 'Commander: Can't connect to FlexRadio SDR-6500: No response from any network.
But I know this computer is working on the network as I'm writing this message on it.
What version of Commander are you using? If it is one of the betas optimized for the Flex you need to go into commander config and put the IP address of your radio in the address box and put 4992 in the port box. This should solve your commander connect message.
Is there a formula you must use to determine the port?
If I click on the 'Net Serv' box, I get a screen saying "Network Service (port 4994) listening."
If I click the 'Default' box it puts the number 52000 into the entry box.
I've done a lot of reboots and can't seem to find the correct combination of info to put into Commander.
But lots of identical error messages