Changing keying delay on Flex 3000 with KE9NS revision software

  • 1
  • Question
  • Updated 2 years ago
  • Answered
Hello everyone,

I have just purchased an old Heathkit SB200 and while I was reassured that the relay in this is high voltage and should be no issue to key the amp, I am concerned about adjusting the keying delay so as to make sure everything is inline before TX starts... looks like I might need roundabout 35ms... where can I change this in PowerSDR Software?
What’s more is I am running KE9NS latest version and I have looked everywhere ... I found how to make PTT hang out longer but that looks different I need to key down and hold Before TX.

Any tips ?

Thanks & 73’s
Jean-Philippe
ZL1RPL
Photo of Jean-Philippe DIEL

Jean-Philippe DIEL

  • 8 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Craig Williams

Craig Williams

  • 89 Posts
  • 35 Reply Likes
Official Response
To answer your question. TX delay for the amp jack delay is at, Setup, General, Options. Enable TX Out Delay.