2.0 registration

  • 2
  • Problem
  • Updated 11 months ago
  • Solved
Took a few tries of the PTT foot switch before it took. Waited a few seconds into the timer window and held the switch a couple of seconds. Got it on the third try. If you run into this issue, don't give up. Might have been network issues, but otherwise a smooth upgrade to my 6300.
Photo of KC7ES

KC7ES

  • 35 Posts
  • 2 Reply Likes

Posted 11 months ago

  • 2
Photo of Joe - KC2TN

Joe - KC2TN

  • 96 Posts
  • 23 Reply Likes
I had the same issue with my foot switch. It works fine for keying the Amp/radio but wouldn't work for the registration process. However, when I switched to using my KEY instead, it worked the first time. Mystery!
Photo of Rudy HB9MHB

Rudy HB9MHB

  • 11 Posts
  • 0 Reply Likes
I had the same with my PTT on the microphone, I need four times then was ok.
Photo of Rick Hadley - W0FG

Rick Hadley - W0FG

  • 554 Posts
  • 118 Reply Likes
It just took a quick tap on the Begali paddles for mine to register.
Photo of KC7ES

KC7ES

  • 35 Posts
  • 2 Reply Likes
I may have found the issue..I inadvertently left my laptop upstairs on, and connected to the LAN. Both DAX and Smart SDR Cat were running (v 1.10.16). That might have caused a conflict. Note to self...