Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?


SmartSDR v4.0.1 and the SmartSDR v4.0.1 Release Notes

SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

on my 8600M, APD & CAL are indicated in blue does this mean APD is on or working?

w5ap
w5ap Member ✭✭
in FLEX-8000 Signature Series

from the TX panel, APD always shows "Calibrating"

Answers

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    When APD is working, it will say ACTIVE.

    There is a bug where the GUI can still be in CAL but it is ACTIVE. You can tell this by looking at the transmitted pedestal. It will be flat looking rather than a triangle. Remember it only works in AM and SSB for the most part.

    If you can't get it to calibrate, try turning down the RF GAIN (not AGC-T). It depends what band you are one for SmartSignal to get an equalizer solution.

    good luck!

  • w5ap
    w5ap Member ✭✭

    I've played with the RF gain (reducing it to 0 or various settings with no success)

    Meanwhile my APD shows Active when on SSB but doesn't seem to flatten the transmit pedestal.

    I'm using a PGXL amp, so I'll have to wait till that equipment is implemented into APD

    I haven't listened to the 8600M barefoot with another rig to observe the waveform

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    If the pedestal is flat in the bottom 1/4, then APD is working. If it looks like a pyramid, it was not able to get a solution.

    You can still use APD with a PGXL but you won't be sampling from the PGXL just yet.

    You can always watch your transmitted signal with another Panadapter/Slice in FDX mode. No need for a 2nd radio. Just select an unused antenna port.

    73

  • w5ap
    w5ap Member ✭✭

    I've also found that when APD is showing Active, changing the transmit power any amount changes the Active to Cal. Then on the next transmission, it goes Active and retains that annunciation.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories