Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v4.1.3 and the SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

No Power Out - CW 6600M

Mike Crownover
Mike Crownover Member ✭✭
in FLEX-6000 Signature Series

I get no power out from the radio. Everything looks normal, receive is good, MOX light comes on when I transmit, but no power out.

I've pushed the Tune button, no power

I've powered down, removed power, then reboot. No Change

I've done a factory reset, no change

The result is the same whether in Smart Contorl or Maestro mode.

Any magic I haven't tried?


Mike AD5A

Comments

  • Trucker
    Trucker Member ✭✭✭✭

    Do you have power out in other modes? On the right side is a dual knob for setting mic gain ( inner knob) and the outer knob is for setting power output. If this is the first time you have tried using CW you may have to set the output.

    James

    WD5GWY

  • Mike Crownover
    Mike Crownover Member ✭✭

    Jim,

    I only do CW contesting with this radio. The power is set at 25 watts, but I've tried it at 100, still no output.


    Mike AD5A

  • David Decoons, wo2x
    David Decoons, wo2x Member, Super Elmer Moderator

    Check your CW pitch. I’ve seen some people have it default to zero where both CW and Tune will not work.


    Dave wo2x

  • Mike Crownover
    Mike Crownover Member ✭✭

    Dave,

    Thanks for the reply, but it was set at 600. I only operate CW with this rig, so all the settings have been in place for a long time.


    73,

    Mike AD5A

  • David Decoons, wo2x
    David Decoons, wo2x Member, Super Elmer Moderator

    Did you open a Help Desk ticket?


    Dave wo2x

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories