Skip to content
  • Register
    • Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
    Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

    SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
    SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
    Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
    Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
    Antenna Genius Utility v4.1.8
    If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
    Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

    Upgrade to 3.3.32 went very well!

    Member, Super Elmer Moderator
    in FLEX-6000 Signature Series

    I just upgraded to 3.3.32 and it went perfectly. I had the low power on CW issue, and that is now completely cleared up - Thank you!

    I tested full power on 160 - 6 CW and all is well.

    Tagged:

    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register

    Comments

    • Member ✭✭✭

      Likewise, just reporting in that upgrade to 3.3.32 went well, as sweet as a nut.

      It took maybe 5 minutes or so, and I was fine as I took some hysteria calming down pills first. Lots of flashing red, purple and green lights etc etc!! I am now rocking' and rollin'.......

      Thank you Flex Radio. You have some very clever people serving us mere mortals.!

      6600M, TGXL, SSDR for Mac and SSDR for Windows.

      73 Mike.

    • Member ✭✭

      Yes just now i'm from V3.2.39 updated to V3.3.32 and it went perfectly

    • Member ✭✭✭

      The same here in my F 6700. It has a new, larger SD card installed and I note that calibration process after radio is switched on takes less time.

      Tom

    • Member ✭✭✭

      You have some very clever people serving us mere mortals.!

      Yes, but a shame they aren't CW operators

    • Member ✭
      The upgrade to v3.3.32 went well for me, also.

      It took less time than I was expecting - maybe 5 minutes or so. I used SmartSDR for the Mac to initiate the firmware update.

      The ATU memory issue has been resolved. Thank you FlexRadio.

      6400 (2019); SSDR for Mac.

      73's, Ron
    • Member ✭✭

      Upgrade was fast and fine. :)

    Leave a Comment

    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register

    Quick Links

    Categories