Skip to content
  • Register
    • Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
    Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

    SmartSDR v3.8.23 and the SmartSDR v3.8.23 Release Notes
    SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
    Power Genius XL Utility v3.8.9 and the Power Genius XL Release Notes v3.8.9
    Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
    Antenna Genius Utility v4.1.8
    If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
    Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

    Flex6400M not showing when "Click to Connent" on SSDR MAC

    Member ✭
    in SmartSDR for Mac
    I am having problem on my MAC/IOS connecting to Flex6400M. It works before. Any ideas?

    Comments

    • Member ✭✭✭

      In my case, when I start SSDR for Mac, and I have an existing xCat or MacLoggerDX up on the same 6600(M), the SSDR Mac will not connect until I disconnect xCat and MacLoggerDX. After that, I can start xCat again, and SSDR will start up when it is running.

      Sent a message to the author a while ago, but got no satisfactory solution. No idea whether this is anything like you are seeing, but that's mySSDR for Mac cross to bear.

    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register

    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register

    Quick Links

    Categories