Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.1.5 | SmartSDR v4.1.5 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Flex6400M not showing when "Click to Connent" on SSDR MAC

georgejoy
georgejoy Member ✭
in SmartSDR for Mac
I am having problem on my MAC/IOS connecting to Flex6400M. It works before. Any ideas?

Comments

  • Ted VE3TRQ
    Ted VE3TRQ Member ✭✭✭

    In my case, when I start SSDR for Mac, and I have an existing xCat or MacLoggerDX up on the same 6600(M), the SSDR Mac will not connect until I disconnect xCat and MacLoggerDX. After that, I can start xCat again, and SSDR will start up when it is running.

    Sent a message to the author a while ago, but got no satisfactory solution. No idea whether this is anything like you are seeing, but that's mySSDR for Mac cross to bear.

Categories