Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v4.1.3 and the SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

emission problem

MENARD PHILIPPE
MENARD PHILIPPE Member ✭
in DAX
during transmission in FT8 mode, there are parasitic lines on all the band.
The level is set at -10db and even at -50db same problem.

I listened in FDX mode on the same tape.
I changed the RX and TX and I see streaks all around the show.
Trouble the whole gang, report by other oms

Comments

  • Mike-VA3MW
    Mike-VA3MW Administrator, FlexRadio Employee, Community Manager, Super Elmer, Moderator admin

    This is being handled as a support case.

This discussion has been closed.

Categories