Profile does not function properly on v3.2.31

Amos Sobel · March 2021

I am using the SmartSDR split to 5 parts. Radio controller a 4 slices. I did save 20 such profiles for diffrent frequency configurations. On the new v3.2.31the screen locations are not saved.

Amos 4X4MF

Tim - W4TME · March 2021

Screen location and the geometry of panadapters were never saved in profiles because they are a client-side configuration and not a radio parameter. Please review what parameters are stored in profiles by referring to the SmartSDR Software User Guide.

What is saved is the number of panadapters, the frequency of the panadapter, and the slices per panadapter (and their frequency). I suspect you will need to reconfigure the Screen location and the geometry of panadapters so that information is restored in the client-side configuration.

Robby · March 2021

I have found another problem. No matter what bandwidth I save in my CW and RTTY profiles it defaults to 400hz. I like to set my CW bandwidth to 250 hz. I had that B/W in my profiles saved from before I upgraded to the new version but as soon as I make a small change to any parameter and re save my profile my CW B/W changes to 400 hz. I rely heavily on profiles to change bands and modes.

Has anyone noticed this problem?

Robby/HP3SS

Amos Sobel · March 2021

Tim

Nevertheless, every time I restore the panadater sizes an locations and save it in the old profile, it is destroyed when I use that profile again.

Amos 4X4MF

Profile does not function properly on v3.2.31

Welcome!

Comments

Leave a Comment

Welcome!

Quick Links

Categories