Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v4.1.3 and the SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

No power out and no waterfall signal

ac5s
ac5s Member ✭
in FLEX-6000 Signature Series
Just received my Flex6400 from Flex a couple days ago (new from Flex). No issues setting up software but upon power up and software connecting to radio, nothing shows on the waterfall on any of the bands and no power out on any bands that my antenna is tuned for. Checked SWR on 7300 and Bird meter and anyenna is good. Upped gain on antenna setting but again no signal present. Everything else on software works. TX light comes on hardware. 13.9 volts Astron 35 amp supply. 2nd Flex so I know my way around somewhat. ?

Comments

  • Jack6600
    Jack6600 Member ✭✭

    Did you try opening a second pan adapter? Can you do a screen shot, crop it and attach it to your reply?

  • ac5s
    ac5s Member ✭
    I think this is what you were asking for. No signal on 2nd slice either
  • ac5s
    ac5s Member ✭
    Rechecked power output and is basically zero on Bird meter in RTTY mode (10, 20, 15 and 40 meters) into vertical antenna at 1.8:1 or better SWR.
  • Alan
    Alan Member ✭✭✭✭

    Perhaps you need to move the divider up, where the waterfall should start to split the screen, with the waterfall on the bottom.

    Place the mouse pointer on the line, just below the signal screen, hold the mouse button down, and move the line up to "split" the screen.

    Alan

    WA9WUD

  • Alan
    Alan Member ✭✭✭✭
    Screen Shot 2020-08-30 at 4.34.05 PM.png


  • ac5s
    ac5s Member ✭
    Have feeling this is software related. I put in a ticket. Paul
  • KD0RC
    KD0RC Member, Super Elmer Moderator

    Hi Paul, go to Settings, TX Band Settings... And make sure that the PTT Inhibit box is not checked for the band of interest. Also make sure that you have the right antenna selected for TX and RX. On the flag in the panadapter, there is a blue ant indicator for RX and a red one for TX.

    73,

    Len, KD0RC

  • Bob KC9RF
    Bob KC9RF Member ✭✭

    TX is not selected on slice A. use your mouse to hover over the TX and make sure it is the color red by selecting with mouse. Test by selecting tune for output power

    Also check your transmit band selection menu for power selections and PTT inhibit as mentioned by KD0RC.

    Bob KC9RF

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories