Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

No TX1 or TX2 or TX3 operation after S/W upgrade

Options
Jerry NG6R
Jerry NG6R Member
edited June 2020 in SmartSDR for Windows
Just upgraded 6600 SmartSDR from v2.1.33 to v3.1.12
(latest version) earlier today.  There
were no hardware or configuration changes done at the same time—just the s/w upgrade.  Now, TX1 (or TX2 or TX3) will not key the Elecraft 1500 amp in any mode.  I pulled the Flex RCA cable plug temporarily from TX1 where the other end goes to the amp, shorted across the RCA plug and the TX lamp on the amp responded as it should by turning red.  So, the cable is still OK and the amp is ready to respond.  But the Flex is not closing the circuit upon PTT or key down.  The Flex is putting out power OK, but the amplifier info monitor window (during Flex transmissions) displays “RF IN, NO KEY IN”.  It’s most likely “pilot error” but I haven’t yet been able to determine what needs to be done.  Any ideas of things to try?

Answers

  • Neal Pollack AB6G
    Neal Pollack AB6G Member ✭✭
    edited June 2020
    Options
    The upgrade likely did not preserve your radio settings or profile.
    Go into the RADIO menu, where you can click boxes to enable
    TX1, TX2, TX3, if that is what you wish.

    Most of the upgrades have release notes that caution you to export/save
    your profiles before upgrade, but it should be easy enough to set what 
    you wish again.

    Cheers,

    Neal

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited June 2020
    Options
    These settings are now configured by band.  From the menu bar, select Settings ->TX Band Settings.  Note that these are TX Profile specific.
  • Jerry NG6R
    Jerry NG6R Member
    edited June 2020
    Options
    Should have examined ALL columns in that table more carefully!  Thanks, Tim.
  • Mike Webb KC0YHM
    Mike Webb KC0YHM Member ✭✭
    edited June 2020
    Options
    I'm betting on Tim...sounds like the fix you're looking for.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories