Does Anyone Have Any Recent MMTTY Screen Shots or Step by Step Instructions for 6000 Series

I will give it a try.

 RADIO

 1) On the Active Slice: flag Select "DAX" and channel 1.

 2) On  "P/CW" Pane" in the control panel:  Select "DAX" and de-select "PROC".  You can do this

In a "MIC" profile.

 SDR CAT

 1 Create a PTT com port.  See picture.

 

MMTTY:

1)      On the TX setup page , upper right corner (PTT and FSK box) and select the com port that you created.

2)      MMTTY “MISC “Page select “TX Port Box” as “Sound”.

This will get you closer.  You should see the red bar active in the DAX control panel channel 1.

You should be see activity in the MMTTY spectral Display.

Put the active slice in RTTY mode, place the two receiver tone lines over the peaks of the in coming signal.  You should be good to go.  Hopefully I haven't forgotten anything. 

Gayle K0FLY

Be sure to a have the mode in RTTY . Dudley