Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v4.1.3 and the SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 and the SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Tune button works for 3 seconds then off

Mike NN9DD
Mike NN9DD Member ✭✭
edited October 2019 in FLEX-6000 Signature Series
Anyone ever seen a behavior like this on a 6500? There doesn’t appear to SWR or RF. When using tune button to tune up the radio will stop transmitting and go back to receive. Never behaved this way till yesterday. You press tune 3 seconds later it drops back to receive When using hand or foot switch will transit as long as trigger is pulled and behaves normally. Would appreciate any thoughts or experience others have had. Other wise I will reinstall software and reload firmware on radio Mike NN9DD

Answers

  • Butch
    Butch Member ✭✭✭
    edited November 2018
    Mike, suggestion.  Make sure you have ANT1 selected and connect this output to a dummy load, then see if you get the same results.
  • K1UO Larry
    K1UO Larry Member ✭✭✭
    edited October 2019
    By any chance  in SSDR setup under the TX tab do you have a value set in the TX timeout ?   Sorry, doing this from memory so i may have the place wrong.  Its in the same tab where you set delays for TX or PTT1,2,3.
  • Mike NN9DD
    Mike NN9DD Member ✭✭
    edited December 2017
    I will check that when I get home tonight. I didn’t see anything. On those tabs out of normal but will double check Thanks and I will follow once solution is found Mike NN9DD
  • Mike NN9DD
    Mike NN9DD Member ✭✭
    edited October 2019

    I reinstalled the Radio and PC software and it seemed to solve the problem

    Mike

    NN9DD

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories