Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
The latest SmartSDR Software:
SmartSDR v4.2.20 | SmartSDR v4.2.20 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

The latest 4O3A Genius Product Software:
The latest 4O3A Genius Product Software and Firmware
How to Receive Technical Support::
If you are needing assistance with FlexRadio products, please refer to the product documentation or check the Help Center for known solutions. Need technical support from FlexRadio? It's as simple as creating a HelpDesk ticket.

Tune Step Ease Needed (like in PowerSDR)

Options
Dave - W6OVP
Dave - W6OVP Member ✭✭
edited April 2019 in New Ideas
Part of the magic of PowerSDR is the ease of tuning by picking the rate of change merely by moving the mouse pointer over that digit. (Instead of burying it somewhere in a TX menu.) It is this simple minded Captain Obvious sort of thinking that we need lots more of in SmartSDR.
3
Up Down
3 votes

In Review · Last Updated

Comments

  • Bill N3HQB
    Bill N3HQB Member ✭✭✭
    edited February 2017
    Options
    In SpectraVue, clicking on the top half of the digit increases the digit by 1; clicking on the bottom half of the digit decreases the digit by 1.
  • Gerald-K5SDR
    Gerald-K5SDR FlexRadio Employee ✭✭
    edited April 2019
    Options
    The tune step is always available with one click on the active slice control panel under the transmitter controls.
  • Dave - W6OVP
    Dave - W6OVP Member ✭✭
    edited December 2016
    Options
    Thank You Gerald. Unfortunately that is totally counter-intuitive. A beginner wants to first learn how to receive. The very last place to look for receiving is transmitting. This is sort of like stopping the car and opening the trunk each time to flip the turn signal.

    PSDR got it right - zero clicks required. Tuning and volume adjust are the 2 most common activities and should be the simplest, most obvious, and most satisfying IMHO.
  • Al_NN4ZZ
    Al_NN4ZZ Member ✭✭✭
    edited December 2016
    Options
    Hi Dave,
    FWIW, the "tool tip" says:

    image


    But it should probably say "Show/Hide RX/TX panel" since the items displayed include the RX panel and the Equalizer for both RX and TX.

    image

    Or maybe even just "Show/Hide Control Panel"  

    I usually leave the panel showing but of course not everyone has the screen space or wants to do that.  There is a request to allow the panels to be docked/displayed separately and even dragged to another monitor if you use more than one monitor.  

    It's hard to come up with a design that works for everyone, so options are good at least from that perspective.   It can be a lot of work though to implement a "drag and dock" panel design if it was not done that way from the start. 

    Regards, Al / NN4ZZ  
    al (at) nn4zz (dot) com

     





     

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories