Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Tuning in the panadapter

Options
Member ✭✭
edited March 2020 in New Ideas
During our crazy wind storm this evening I am setting up for the NAQP. Just about done but I would like to request something for the next release if possible. With two panadapters open each with one slice if I am active on the bottom one and want to then work from the top one I cannot click tune to change frequency. I first have to click the line showing the frequency /bandwidth indicator and then I can click tune. I can understand the current setup IF there are more than one slices open on a panadapter.....but if there is only one I should not have to make that extra step in order to click tune. Thanks!! Looking forward to NAQP if my drugs hold out. :) 73 Greg

Comments

  • Member ✭✭
    edited March 2020
    +1!
  • Member ✭✭
    edited September 2014
    To further amplify, any time there is a single slice in any pan adapter, clicking anywhere in the pan adapter should tune the slice without having to do anything to the slice before hand.

Leave a Comment