Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?

SmartSDR v3.9.19 and the SmartSDR v3.9.19 Release Notes
SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes

The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Tuner problems

Member ✭✭
edited April 2020 in SmartSDR for Windows
Replaced my ICOM 756 with the Flex-6500 feeding an MFJ 1775. The Flex won't tune 30, 17, 12, and surprisingly, 10. On those bands, the ATU engages and then cycles (clicks on and off) at about 60 - 90 hz and I have to manually abort the operation. Flex SWR shows in excess of 3:1. The antenna on 10 shows less than 3:1. The MFJ 1775 advertises it will tune the above with a tuner. The Icom tuned all of them and has a much narrower tolerance.

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • Member
    edited October 2018
    You neglected to mention what version of SSDR code you have installed?
  • Member ✭✭
    edited August 2016
    Running pre-release and 2.6.4. Had it about a week and still learning.
  • Member ✭✭
    edited August 2016
    client: v0.13.10.36751 hardware: v0.13.2.14
  • Member ✭✭
    edited April 2020
    I must use a LDG z-11proII to tune my antenna with my 6500 on those same bands. my T1, kx3, and of course the LDG all tune 3.5 to 52MHZ to 1.1. My Flex refuses! Was there an update to the tuner code?
  • Inactive Employee
    edited March 2018
    Try shutting everything and removing the DC from the radio for atleast 30 seconds and then try it again.. Some times just a good cold start will correct everything. If the issue continues, please open a Support Ticket call on the FlexRadio Help Desk. http://helpdesk.flexradio.com That will get it logged into the system.
  • Member ✭✭
    edited February 2019
    I never see more than 75 watts out of my 6700 into a perfect 1:1 dummy load. This is distressing me Dave, W5UN

Leave a Comment

Welcome!

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories