SmartSDR+, 4.01 FW, don't see a change

Mark_WS7M

I am mostly using SSDR Mac but not seeing a way to upgrade there I did the upgrades on my I9 Windows PC. My radio (6600) is now on 4.0.1. I used the radio setup to subscribe to SmartSDR+. It succeeded and after a refresh says: Subscription SmartSDR+. Licensed v4.

SmartSDR shows the digital voice keyer, but it seems disabled. I also cannot find the CW auto-tune button anywhere.

The charted posted by Mike says the 6600 should also get ANFL and ANFT. These are grayed out in USB.

So not sure what is going on.

Mark_WS7M

Also I did early access which charged a BUNCH more bucks and that got DVK and finally found autotune.

Did I need to do both "Get SmartSDR+" and "Get Early Access"?

It was a heck of a lot of $$$ for not many features. I have a 6400 and at this point I seriously doubt I will pay this money again. I shudder to think about those of you with many Flex Radios having to pay this per radio…

KD0RC

Hi Mark, I would contact Flex sales. If you want Early Access, you just pay for that, not both. Early Access is $100 more than SmartSDR+.

9A5GG

Hello, guys, I have the same question about SDR+. I paid for SDR+, but it's also not unlocked on my device. My question is, should I wait now for it to unlock after a while, or should it be available immediately?

Trucker

If the button in the menu to purchase upgrades for SmartSDR Plus is no longer green, but is grayed out, your purchase has went through. You won't see the new features until November 30th as they don't become active until 30 days after they were originally released. So, you have a few more days to go before they become active. If for some reason, they don't become active ( the buttons for the different features change from gray to normal) then, you will need to open a Help Desk ticket to help you solve the problem.

James

WD5GWY